Yanmar 6CXM-GTE2 Operation Manual page 40

Maintenace & Inspection
5
5.2.3 Inspection Every 250 Hrs,
or 1 year.
(1) Replacing the Fuel Filter
Replace the fuel filter periodically before there is
clogging and the fuel flow is reduced.
1 Close the fuel cock of the fuel tank.
2 Turn the fuel filter to the left with the filter wrench
and remove.
3 Clean the attachment face for the filter.
4 Turn the new filter to the right until it contacts the
attachment face. After tightening by hand, use
the filter wrench to tighten it another 3/4 of a turn.
(Tightening torque: 11.8~17.7 Nm/1.2~1.6kgm)
5 Bleed the fuel system.
40 |
MARINE DIESEL ENGINE 6CXM-GTE2
See 3.2.2.

Fuel filter
Drain plug
(2) Replacing Cooling Water
Cooling performance drops when the cooling water
is contaminated with rust and scale. Even if antifreeze
or antirust is added, the cooling water must be
periodically replaced because the properties of the
agent will degenerate. Replace the cooling water
periodically.
• Draining the Cooling Water
• Supplying Cooling Water
(3) Replacing the Engine Oil and Lube Oil
Filter (2nd time & after)
After the second oil change, the engine oil should be
replaced after every 250 hours. Replace the lube oil
filter at the same time. See 5.2.1 (1)

See 4.8.1 (2)

See 3.4

>