Yanmar 6CXM-GTE2 Operation Manual page 24

How to Operate
4
4.2 Checking the Instrument Panel and Alarm Devices
Be sure to check the alarm devices and other
instruments on the panel before and after starting
the engine. If the devices are not working properly,
it is impossible to prevent any problems arising from
insufficient oil and water in the engine. Make it a
regular practice to check the alarm and other devices
before and after starting.
4.2.1 Checking the Instrument Panel
Lamps
Turn on the light switch on the upper right side of the
instrument panel and check to see that the panel lights
switch on.
24 |
MARINE DIESEL ENGINE 6CXM-GTE2
(Instrument panel is optional)
4.2.2. Checking the Alarm Devices
(1) Check before starting.
1 Turn on the battery switch.
2 Put the key in the starter switch.
3 Turn the key from the OFF position to ON and
check to see that the alarm devices as shown in the
diagram (Before Starting) are working properly.
• Buzzer sounds.
• Charge and other lamps light up.
Function of Alarm Devices
Key Operation
Alarm Buzzer
Alarm Lamps
Charge Lamp
Cooling Water Temperature
Engine Oil Pressure
Engine Oil Filter
Note: The amount of time for 'On briefly' is approx. 3 seconds.
(2) Check after starting.
When the key returns from the START position to ON,
check to see that the alarm devices as shown in the
diagram [After Starting] are working properly.
• Buzzer stops.
• All of the lamps switch off.
By performing these procedures, it can be determined
whether or not the electric circuit is in good working
order. If there is any problem, consult your Yanmar
dealer. See 2.4.1 (2)

Before After
Starting Starting
OFF START
ON ON
 
On Off
On Off
On briefly Off
On Off
On briefly Off
>