Man D2842 LE103 Operating Instructions Manual page 52

MAN-Industrial diesel engines D2842 LE103
Maintenance and Care
Filling Engine Oil
IMPORTANT!
Termination of liability for material defects by use of non-approved fluids and lubric­
ants!
Liability for material defects is terminated if non-approved fluids and lubricants are used.
For this reason:
S Only use approved fluids and lubricants (see "Fluids and Lubricants ..." publication).
IMPORTANT!
Component damage caused by
over filling!
Engine damage can occur if engine
oil is filled to above the max. mark
on the oil dipstick.
For this reason:
S Do not fill engine oil above the
max. mark on the oil dipstick
1. Remove cap (1).
2. Fill engine oil slowly via the filler neck.
For oil filling level see "Technical Data",
page 76.
3. Reinstall cap (1).
IMPORTANT!
Components can be damaged
due to no oil pressure!
After 10 seconds the running en­
gine must cause the oil pressure to
build.
For this reason:
S Observe oil pressure indicator.
S Check oil pressure and check for
leaks.
S If no oil pressure builds up,
immediately shut down engine.
S Determine cause and rectify
problem.
4 Start engine and let it run for a few minutes at
low speed.
5. Shut down the engine.
6. Check engine oil level after 20 minutes.
52
Carefully read the Operating Instructions before starting any work!
This is especially valid for the chapter on General Safety Instructions
and the safety instructions in each of the chapters.
MAX
MIN
1