Table of Contents
Advertisement
ELITE Series Adjustable Portable Backstop Instructions
floor. If the height is not correct, refer to section 9 for details
on how to remove the padding and check the state of the
foot stops (Figure 8-3).
6. ONLY IF BACKBOARD IS INSTALLED, remove the quick-release pin
from the height adjuster mechanism (Figure 7-1).
a. It may be necessary to lift handle slightly in order to pull the
pin.
7. Stand to one side of the unit and lift one of the two handles on the
lower upright (Figure 8-2).
f. If raising the backstop is too strenuous obtain assistance
before attempting to raise.
g. Be sure to maintain control of the uprights while raising. Do
not release handle while raising.
11.2 Lowering Backstop
1. Remove the quick-release pin.
2. Pull back on handles until backstop is fully lowered.
a. Always stand on the same side of the unit as the ring on the
quick-release pin when pulling the pin; never reach across to
the other side of the upright to pull the pin.
b. See Figure 8-1for details on where to safely stand.
3. Pin the unit in the lowered (transport) position.
4. Raise the feet until both feet are off the ground and the unit rolls
freely on all four wheels.
12 Spring Adjustments
WARNING: DO NOT REMOVE SPRINGS UNDER ANY CIRCUMSTANCES. IF YOU SUSPECT THAT
A SPRING IS DAMAGED AND REQUIRES REPLACEMENT CONTACT JAYPRO IMMEDIATELY AT
(800) 243-0533.
WARNING: WHEN ADJUSTING THE SPRINGS ALWAYS ENSURE THAT THE LOCKNUTS ARE
NEVER LOOSENED TO THE POINT WHERE NO THREADS ARE VISIBLE.
Adjusting the lift-assist springs and should only be used by an experienced
contractor/installer. Please contact the Jaypro Sports customer support
team, Monday through Friday, 8:30AM to 5:00 PM (EST), at 1-800-243-0533
if assistance with locating an experienced professional is required.
- 25 of 27-
JSL-Inst039
www.jayprosports.com
Advertisement
Table of Contents
