Related Manuals for Jaypro CARBON ULTRALITE
Summary of Contents for Jaypro CARBON ULTRALITE
- Page 1 3” OD N AYPRO ARBON LTRALITE YSTEM Installation and Operating Instructions Applicable Part Numbers/Models: PVB-9500: Carbon Ultralite 3” System...
-
Page 2: Table Of Contents
PVB-9500 Jaypro Carbon Ultralite 3” OD Net System Instructions Table of Contents Safety ........................ 2 Specifications ....................2 Introduction ..................... 2 Required Tools ....................3 Included Hardware & Components ............4 5.1 System Components (ACCESSORIES MAY VARY) ......4 5.2 Hardware ....................5 Assembly ...................... -
Page 3: Safety
The Flex-Net will work with ground sleeves spaced 35’ to 37’ apart on center NCAA and NFHS rules require that the upright standards must be installed at least 3’3” (1m) outside the court boundaries. Jaypro recommends 36’ spacing on center to satisfy both regulations. -
Page 4: Required Tools
PVB-9500 Jaypro Carbon Ultralite 3” OD Net System Instructions Figure 3-1: Correct Ground Sleeve Dimensions Required Tools Before continuing, please verify that you have the following tools required to complete the installation and setup of your PVB Series Collegiate Net System. -
Page 5: Included Hardware & Components
Before continuing, please open all packages to verify that you have all the required hardware for installation and setup. If any of the following items are missing, contact the Jaypro Sports customer support team, Monday through Friday, 8:30AM to 5:00 PM (EST), at 1-800-243-0533. -
Page 6: 5.2 Hardware
PVB-9500 Jaypro Carbon Ultralite 3” OD Net System Instructions Figure 5-5: Antennae and Net Tapes (VBA-80, 1 pair) 5.2 Hardware Figure 5-6: Net extension cord 31 inches (PVBN6R2, 2X) Figure 5-7: Socket Cap Screw (HS5082, 1X) Figure 5-8: Centering Strap (PVB604, 1X) -
Page 7: Assembly
PVB-9500 Jaypro Carbon Ultralite 3” OD Net System Instructions Assembly 1. Install each upright into the ground sleeves. * The bottom 10 inches of the standards have been covered with an outer layer to improve fit in most ground sleeves. If fit is too tight, cut outer layer with knife and remove. - Page 8 PVB-9500 Jaypro Carbon Ultralite 3” OD Net System Instructions 5. Fasten anchor strap assembly to non-winch pole with the button head scre, spacer, and acorn nut as shown below. Figure 6-2: Anchor strap installation. 6. Install net extension cords to the winch strap and anchor strap assembly and install carabiners to the free ends of net extension cords (Figure 6-3).
- Page 9 PVB-9500 Jaypro Carbon Ultralite 3” OD Net System Instructions 7. Set the height of the uprights using the installed height adjust pin (Figure 6-4). WARNING: Release tension from the net, if installed, before removing height adjust pin. Figure 6-4: Set upright height.
-
Page 10: Maintenance
PVB-9500 Jaypro Carbon Ultralite 3” OD Net System Instructions 11. Attach the bottom net straps to each upright as shown in Figure 6-5. Wrap Velcro straps around buckles for additional player safety. Figure 6-5 : Secure bottom net straps to uprights.