Pull-Up Speed Control - Idex BAND-IT S10099 Manaul

Pull-Up Speed
Control
PULL UP SPEED CALIBRATION
1. START WITH PISTON ROD IN FORWARD POSITION AND SET SCREW WITH JAM NUT ALL THE
WAY BACK (SCREW END FLUSH WITH BOSS). PUT SLOW / FAST SELECTOR ON "SLOW".
2. SLOWLY PUSH VALVE HANDLE FORWARD UNTIL PISTON GLIDES BACK AND PRESSURE
INDICATES ON THE PRESSURE GAUGE.
3. KEEP HANDLE IN THAT POSITION AND TURN SCREW OUT UNTIL IT CONTACTS THE SURACE OF
THE SLOW / FAST SELECTOR. HOLD SCREW IN POSITION WITH HEX WRENCH AND TIGHTEN
JAM NUT.
4. CHECK CALIBRATION BY CYCLING TOOL ON BOTH SLOW AND FAST PULL UP. OBSERVE THE
DIFFERENCE IN PISTON SPEED.
FOR APPLYING MOST ALL BAND-IT PREFORMED CLAMPS, PULL SPEED CONTROL SHOULD BE IN "UP"
(FAST) POSITION.
CASES WHERE PULL SPEED CONTROL MAY BE USED IN "DOWN" (SLOW) POSITION ARE:
A) WHEN EXACT POSITIONING OF CLAMP IS REQUIRED.
B) FOR APPLYING CLAMPS TO LARGE OR HEAVY AND HARD TO HANDLE HOSE.
C) TRAINING A NEW OPERATOR.
D) IF CLAMPS ARE NOT PULLING SMOOTHLY.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
SET SCREW
VALVE HANDLE
SLOW / FAST SELECTOR
PRESSURE GAUGE
www.BAND-IT-IDEX.com
Page 7 of 18
S10099
Classic Air Tool
JAM NUT
BOSS
Document # P09287 rev. L
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved