Table of Contents
Advertisement
Operating
Pressure
OPERATING PRESSURES SHOWN BELOW ARE IN PSI
CLAMP WIDTH
INCH
mm
1/4"
6.4
3/8"
9.5
1/2"
12.7
5/8"
15.9
3/4"
19.1
NOTES:
THESE ARE RECOMMENDED MAXIMUM PRESSURES FOR BAND-IT JUNIOR
REDUCE PRESSURE SETTINGS TO PROPERLY CLAMP SOME OBJECTS.
USE ONLY BAND-IT CLAMPS ON THE AIR TOOL.
WHEN CLAMPING A HOSE END, REMEMBER THAT A TIGHTER CLAMP KEEPS THE FITTING MORE SECURE, BUT EXCESS
TENSION COULD DAMAGE THE HOSE. FITTING STEM MUST HAVE PROMINENT BARBS FOR PROPER RETENTION INSIDE
THE HOSE, BUT MUST NOT BE SHARP TO PREVENT CUTTING INTO THE HOSE. HOSE, FITTING AND CLAMP MUST BE
COMPATIBLE WITH EACH OTHER AND THE WORKING ENVIRONMENT USED IN. IF IN DOUBT, CONSULT THE HOSE OR
FITTING MANUFACTURER OR CALL BAND-IT.
CLAMPING OBJECTS OTHER THAN HOSE REQUIRE SIMILAR PRECAUTIONS.
CAUTION: IMPROPERLY TIGHTENED CLAMPS MAY RESULT IN DANGEROUS HOSE ASSEMBLIES, WHICH COULD CAUSE
INJURIES OR PROPERTY DAMAGE.
CAUTION: ABUSE OR USE OF A HOSE OUTSIDE THE MANUFACTURER'S RECOMMENDED CONDITIONS MAY CAUSE IT
TO QUICKLY DETERIORATE AND BECOME A SAFETY HAZARD. THIS COULD RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE. INSPECT AND TEST HOSE ASSEMBLIES FREQUENTLY. REPAIR OR REPLACE AT THE SLIGHTEST
SIGN OF DAMAGE OR DETERIORATION.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
201 STAINLESS STEEL
PULL UP
HOLDING
PRESSURE
PRESSURE
15
4
25
5
40
6
50
7
60
8
IMPORTANT ADVICE AND WARNINGS TO USER.
READ BEFORE APPLYING CLAMPS.
www.BAND-IT-IDEX.com
Page 6 of 18
316 STAINLESS STEEL
PULL UP
HOLDING
PRESSURE
PRESSURE
15
4
20
5
35
6
40
7
50
8
®
CLAMPS. IT MAY BE NECESSARY TO
S10099
Classic Air Tool
CARBON STEEL
PULL UP
HOLDING
PRESSURE
PRESSURE
--
--
25
6
40
7
50
8
60
9
Document # P09287 rev. L
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
Advertisement
Table of Contents
