Table of Contents
Advertisement
Maintenance
1. FOR BEST RESULTS AND PROPER FUNCTIONING OF THE AIR
TOOL, A FILTER / LUBRICATOR MUST BE USED ON THE AIR
SUPPLY OR IN LINE WITHIN 30 INCHES OF THE AIR TOOL.
THE WARRANTY IS VOIDED IF A FILTER / LUBRICATOR IS
NOT USED.
2. BEFORE USING AIR TOOL, CHECK TO SEE THAT THE
CUTTER BLADE AND BACKING PLATE ARE FULLY
TIGHTENED. LOOSE BOLTS CAN EASILY CAUSE BREAKAGE
OF BLADE AND BACKING PLATE.
3. CLEAN GRIPPER OCCASIONALLY. PARTICLES AND DIRT ON
THE GRIPPER LEVER CAN CAUSE IT TO SLIP OFF THE
CLAMP TAIL. TO REMOVE GRIPPER LEVER, SLACKEN OFF
SET SCREW AND TAP OUT PIN.
4. CUTTER BLADE AND BACKING PLATE EDGES MUST BE KEPT
CLEAN AND FREE OF METAL SHAVINGS. HONE SMOOTH AT
FIRST SIGN OF CLAMP GOUGING.
THE BAND-IT S10099 AIR TOOL, ALTHOUGH DURABLE, DOES NEED PERIODIC MAINTENANCE AND
REPAIR. IF THIS TOOL NEEDS MINOR REPAIR OR COMPLETE OVERHAUL (LIST BELOW), IT SHOULD BE
RETURNED TO BAND-IT IN DENVER, COLORADO.
MINOR REPAIR:
1.
TEST AND INSPECT TOOL TO DETERMINE SOURCE OF PROBLEM.
2.
CLEAN EXTERIOR OF TOOL.
3.
REPLACE WORN OR DAMAGED, EXTERNAL EXPENDABLE PARTS.
4.
ADJUST, TEST AND INSPECT.
REPLACE CUTTER BLADE AND BACKING PLATE AS KIT J93099.
REPLACE GRIPPER CLOSING SPRING AND BAND GRIPPER AS KIT S45199.
PARTS REPLACED ARE INVOICED AT CURRENT PART PRICES.
OVERHAUL:
1.
TOTALLY DISMANTLE TOOL AND CLEAN ALL PARTS.
2.
REFINISH EXTERNAL PARTS SUCH AS CASTINGS, CYLINDER, ETC.
3.
INSPECT ALL PARTS FOR WEAR AND DAMAGE. REPLACE AS NEEDED.
4.
REPLACE ALL EXPENDABLE PARTS SUCH AS GASKETS AND O-RINGS.
5.
REASSEMBLE, ADJUST, TEST AND INSPECT.
EXPENDABLE PARTS REPLACED AT NO EXTRA CHARGE.
ALL OTHER PARTS REPLACED ARE INVOICED AT CURRENT PART PRICES.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 12 of 18
Classic Air Tool
CUTTER BLADE
BACKING PLATE
BAND GRIPPER
Document # P09287 rev. L
BAND-IT-IDEX, Inc. 2006
S10099
© Copyright
All rights reserved
Advertisement
Table of Contents
