Ecom Instruments x.com 500-Ex Safety Instructions page 5

Only valid for model
- Only the original battery module AMX 50 (Li-Polymer 3.7V) should be used!
- The charging socket cover must be firmly engaged in the unit.
- When changing the battery (after use in the dust Ex-area) the unit and the battery terminals
are to be checked for cleanliness and cleaned, if necessary, using suitable means (brush,
compressed air, etc.).
- It must be ensured that the unit is not taken into zones 0 and 1 or 20 and 21!
Only valid for model
- In principle the unit should not be taken into the dust Ex-area!
- Only the original battery module AMX 51 (Li-Polymer 3.7V) should be used!
- The exposed interface contacts should always be checked for cleanliness and cleaned, if
necessary, using suitable means (e.g. brush, compressed air, moistened cloth / diluted soapy
water or commercially available handwash).
- It must be ensured that the unit is not taken into zones 0 and 1 or 20, 21 and 22!
Only valid for model
- Only the original battery module AMX 60 (Li-Polymer 3.7V) should be used!
- The charging socket cover (safety plug) must be firmly engaged in the unit.
- When changing the battery (after use in the dust Ex-area) the unit and the battery terminals
are to be checked for cleanliness and cleaned, if necessary, using suitable means (brush,
compressed air, etc.).
- It must be ensured that the unit is not taken into zones 0 or 20!
Only valid for model
- In principle the unit should not be taken into the dust Ex-area!
- Only the original battery module AMX 61 (Li-Polymer 3.7V) should be used!
- The exposed interface contacts should always be checked for cleanliness and cleaned, if
necessary, using suitable means (e.g. brush, compressed air, moistened cloth / diluted soapy
water or commercially available handwash).
x.
com 50x -Ex
x.
com 51x -Ex
x.
com 60x -Ex
x.
com 61x -Ex
21