Advertisement
FUNCTION AND OPERATION (continued)
Customization Options
Shut-off Delay
The Shut-off delay is the length of time the light will stay at high-
level brightness after motion has ceased to be detected. This
Shut-off delay can be set when operation is in "OFF", or "AUTO"
mode by using the "TIME" knob located on the left side of the panel
at the back of sensor head (See Fig.5) . To increase the shut-off
delay, turn the knob clockwise. To decrease shut off delay,
turn the knob counterclockwise. The delay may be adjusted from a
minimum of 5 seconds to a maximum of 3 minutes. The light will stay
on as long as motion is detected continuously and will automatically
turn to low-level brightness when no more motion is detected after
the delay time has passed.
NOTE:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. For best performance,
gently clean the lens with a soft cloth every 1 or 2 months to
assure maximum sensitivity.
2. For best performance, install fixture at least 6 feet above
the ground. At such a height, the fixture will provide a
detection distance of up to 40 feet at 77 degrees
Fahrenheit. (See Fig.6)
3.The sensor detects across a detection range of 180 degrees.
(See Fig.7)
4. The sensor will be more sensitive to motion across its
detection path than motion directly towards it. (See Fig.8)
5. To reduce possible nuisances, do not mount the fixture
near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or
other light source.
The following parts are available for re-order if damaged or missing. Call toll free at 800-482-9235.
Spare Parts List:
AA
Cross Bar
X1
BB
Mounting Screw
X2
Assembly Kit
5560MM (1 SET)
CC
Wire Connector
X3
DD
Headless Screw
X2
Page 5 of 6
Fig. 5
(View from back of sensor head)
TIME
TEST
OFF
Where you install your lantern is important:
Be sure the light is mounted straight on the wall;
otherwise, the detection distance may be limited.
Fig. 6
10`
6`
5`
40`
Fig. 8
Motion
Sensor
Least sensitive
EE
Ball Nut
X2
FF
Lock Nut
X4
Glass Shade
9818CS
LOW LEVEL
SENS
PC
AUTO
Model
Fig. 7
180˚
Motion
Most sensitive
GG
Rubber Pad
X2
180726
Advertisement
