Advertisement
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
"TIME" Knob
"LOW LEVEL" Knob
SENS
LOW LEVEL
TIME
PC
TEST
AUTO
OFF
FUNCTION AND OPERATION
Sensitivity of Motion Sensor
The sensitivity of the motion sensor can be adjusted by using the "Sens" knob located on the right side of the panel at
the back of sensor lens (See Fig.5). To increase sensitivity, turn the knob clockwise. To decrease sensitivity, turn the
knob counterclockwise. The sensitivity may be adjusted from a minimum of 5 feet to a maximum of 40 feet.
Choose a mode by sliding the switch at the back of sensor lens. When power is first applied, the light will turn on
immediately. Wait for 100 seconds to allow the sensor to warm up.
1. TEST MODE (daytime and nighttime operation)
• The light will turn to low-level brightness (0~50%).The light will turn to high-level brightness (full brightness)
when motion is detected,and stay on as long as the motion continues. The light will revert to low-level
brightness you set about 5 seconds after motion is no longer detected.
2. OFF MODE (nighttime operation only)
• At dusk, the light will turn on when motion is detected, and stay on as long as the motion continues. When
the motion stops, the light will remain on for the predetermined time set (5 ~ 180 seconds), then the light will
turn off automaticlly.
3. AUTO MODE (nighttime operation only)
• At dusk, the light will turn to low-level brightess (0~50%). The light will turn to high-level brightness (full
brightness) when motion is detected, and stay on as long as the motion continues. When the motion stops,
the light will remain on for the predetermined time set (5 ~ 180 seconds), and then revert to low-level
brightness you set.
• The light will turn off automatically at dawn.
4. PC MODE (nighttime operation only)
• The light will turn to high-level brightness (full brightness) at dusk. It will turn off at dawn.
5. Manual Override MODE (nighttime operation only)
• To shift to the manual override mode, set the switch to "OFF"
or "AUTO" mode.Turn the wall switch "OFF" and then turn it
"ON" within 3 seconds.The light will remain on all night long.
To shift back to the "OFF" or "AUTO" mode, turn the wall
switch "OFF" and then turn it "ON" within 3 seconds again.
(See Fig.4)
• The light will last only for one night and turn off automatically
at dawn.
Note: 1.You can adjust the low level brightness (0~50%) by rotating
"LOW LEVEL" knob at the back of sensor lens. (See Fig.5)
2.To make sure the above functions operate properly, always keep the wall switch in the "ON" position
(including the daytime).
3. Please notice the warm up time is 100 seconds, any operations are invalid during this time.
"SENS" Knob
Flathead Screwdriver
(not included)
Slide Switch
Detail A View
Step 1: Rotate the sensor lens counterclockwise to show
up the adjustable knobs and slide switch.
(See Fig.1)
Step 2: Use the small flathead screwdriver to adjust time,
low level brightness and sensitivity. And slide the
slide switch to choose desired mode. (See Fig.2
and Detail A view).
Step 3: Rotate the sensor lens clockwise to restore original
position.(See Fig.3)
Fig. 4
OFF Mode
AUTO Mode
Page 4 of 6
Turn wall switch OFF-ON
in 0.5~3 Seconds
Manual
Override
Turn wall switch OFF-ON
in 0.5~3 Seconds
180726
Advertisement
