Vaxcel T0672 Assembly And Installation Instructions

Download this manual

ASSEMBLY AND INSTALLATION

T0672

WARNING:

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Hardware Package (included):

Drywall Screw (A)

Important to Know:

1. This fixture requires a 120 VAC, 60 Hz power source.

2. For general safety and to avoid any possible damage to the sensor, be sure the power is switched "off "

before adjustment.

3. Motion sensor: turns light ON automatically when motion is detected and turns light OFF automatically

when motion stops.

4. Photocell keeps the light OFF during daylight hours.

5. When in manual override mode, use wall switch to keep the light ON during the night.

Maximum Wattage: 13W

Work Temperature: - 4°F~113°F

Note: Fixture can be wall mounted only.

Fig.1

INSTRUCTIONS

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Anchor (B)

Wall Mounted

Read notes section on page 4-5 for additional

information about mounting location of fixture.

Light fixture and sensor should be mounted as

shown when installed.

Page 1 / 4

Decorative Cover (C)

220815

Page 1 ASSEMBLY AND INSTALLATION INSTRUCTIONS T0672 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
Page 2 Decorative Cover (C) Drywall Screws (A) Mounting Bracket Set Hole Fixture Light Outlet Socket Anchor (B) Set Screw Installation Steps Turn off the power at fuse or circuit box The mounting bracket is pre-assembled on the light fixture. Unscrew set screw to remove the mounting bracket. 2.
Page 3 . “ ” MODE(nighttime operation only) ● Turn the knob counter clockwise to“ ” position, the light turns on after expiration of the warm-up period, it stays on when motion is detected. When motion is no longer detected, it remains on for the predetermined shut-off delay time you set (5s~3min), and then turns off automatically.
Page 4 The following parts are available for re-order if damaged or missing. Spare Parts List: Assembly Kit 6286MM (1 SET) Drywall Screw (A) Anchor (B) Decorative Cover (C) TROUBLESHOOTING ---The light does not come on at all: 1. Make sure the wall switch and circuit breaker are on. 2.