Routes - Dell SonicWALL GX250 Manual

Routes

If you have routers on your Local Area Network, you have to configure the Static
Routes section of the SonicWALL.
Click Advanced on the left side of the browser window, and then click the Routes tab
at the top of the window.
The SonicWALL LAN IP Address, LAN Subnet Mask, WAN IP Address and WAN/DMZ
Subnet Mask are displayed in the Current Network Settings section. Refer to these
settings when configuring your Static Routes.
To add Static Route entries, complete the following instructions:
1. Enter the destination network of the static route in the Dest. Network
field. The destination network is the IP address subnet of the remote
network segment.
Note: If the destination network uses IP addresses ranging from "192.168.1.1" to
"192.168.1.255", enter "192.168.1.0" in the Dest. Network field.
2. Enter the subnet mask of the remote network segment in the Subnet mask field.
3. Enter the IP address of your router in the Gateway field. This IP address should
be in the same subnet as the SonicWALL. If your router is located on the
SonicWALL LAN, the Gateway address should be in the same subnet as the
SonicWALL LAN IP Address.
4. Select the port on the SonicWALL that the router is connected to, either LAN, WAN
or DMZ, from the Link menu.
Page 102 ADVANCED FEATURES