Table of Contents
Advertisement
3
SonicWALL INSTALLATION
This chapter describes the procedure to install your SonicWALL and perform the initial
configuration.
Inspecting the Package
The following items should be included in the package:
•
One SonicWALL Internet security appliance
•
Two power supplies
•
One Category 5 Ethernet crossover cable (labeled "Crossover")
•
One Category 5 Ethernet standard cable
•
Two fiber optics cables (fiber optics NIC only)
•
One Companion CD
•
One SonicWALL Internet Security Appliance User's Guide
If an item is missing from the package, contact SonicWALL, Inc. by phone at (408) 752-
7819 or submit a Web Support Form at http://www.sonicwall.com/support/.
Overview
Here are a few helpful guidelines for installing the SonicWALL appliance.
•
The WAN Ethernet port should be connected to the Internet router or modem.
•
The LAN Ethernet port should be connected to a network hub or switch on the
internal, protected network.
•
The DMZ Ethernet port, included with the SonicWALL GX250 and GX650, should
be connected to publicly accessible servers, such as Web and Mail servers.
•
A crossover cable should be used when connecting the SonicWALL directly to an-
other machine or router.
•
A standard Ethernet cable should be used when connecting the SonicWALL to a
network hub, switch, or modem.
•
If using the fiber optics network interface card, remove the plug from the network
card to access the network ports on the front of the GX.
Note: During the installation, access to the Internet is interrupted. You can minimize
this interruption by pre-configuring the SonicWALL before you install it.
Page 20 SonicWALL INSTALLATION
Advertisement
Table of Contents
