Advertisement
10
Electrical information
THIS APPLIANCE MUST BE EARTHED.
This appliance is fitted with a fused three pin plug to BS 1363
which will be suitable for use in all houses fitted with sockets to
current specifications.
If the fitted plug is not suitable for your socket outlets, it should be
cut off and carefully disposed of. To avoid a possible shock
hazard, do not insert the discarded plug into a socket.
Fitting a new plug
If for any reason you need to fit a new plug, the flexible mains lead
must be connected as shown here. The wires in the mains lead fitted
to this appliance are coloured in accordance with the following code:
CONNECT GREEN AND YELLOW TO EARTH (E)
CONNECT
BLUE TO
NEUTRAL (N)
MAKE SURE THE OUTER
SHEATH OF THE MAINS
LEAD IS SECURELY HELD
BY THE CLAMP
If the colours of the wires in the mains lead of this appliance do not
correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured Green and Yellow MUST be connected
to the terminal which is marked with the letter E (Earth) or symbol
or coloured Green. The wire which is coloured Blue MUST be
connected to the terminal which is marked with the letter N or
coloured Black. The wire which is coloured Brown MUST be
connected to the terminal which is marked with the letter L or
coloured Red.
Before refitting the plug cover, check that there are no cut or stray
strands of wire inside the plug. Use a 13 Amp BS1362 fuse, only
BSI or ASTA approved fuses should be used. If you are in any way
unsure which plug or fuse to use, always refer to a qualified
electrician.
Note: After replacing or changing a fuse on a moulded plug which
has a fuse cover, the cover must be refitted to the plug, the
CONNECT
appliance must not be used without a fuse cover. If lost,
BROWN TO
replacement fuse covers can be obtained from an electrical shop.
LIVE (L)
13 AMP FUSE
This appliance complies with the following EEC Directives:
73 / 23 EEC (Low Voltage Directive)
89 / 336 EEC (EMC Directive).
Advertisement
