Display Assembly - HP 14s Maintenance And Service Manual

Display assembly

NOTE: Display assemblies are offered as spare parts only at a subcomponent level.
Before removing the display assembly, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the display assembly:
1. Disconnect the display cable from the system board (1).
2. Disconnect the antenna cables from the WWAN module (2).
3. Disconnect the antenna cables from the WLAN module (3), and then remove the cable from the routing
path next to and over the USB, card reader, and power button board (4).
4. Open and position the computer with the display hanging off the table (1).
5. Remove the five Phillips M2.5 × 6.0 screws (2) from the hinges.
46 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page 25).
22).
23).