The EASTWOOD WORK BENCH features a spacious 61” x 30” work surface with a 2” retaining fence on three sides. The heavy, all steel construction supports up to a total loaded weight of 1600 lbs. [725kg.] with a fully open frame to allow for under bench storage or placement of welders, compressors and other equipment.
DO NOT stand on the Work Bench. • The Eastwood Work Bench consists of moderately heavy metal components which can cause potentially serious injuries if allowed to drop. Avoid pinching hands while handling parts during assembly. Obtaining the assistance of a helper during assembly is necessary.
Page 4
• Add another M12 Washer then thread on an M12 Nut (FIG 2). Tighten firmly but allow for final leveling adjustment after complete assembly. • Repeat for remaining three sets. FIG. 2 A, B & C FIG. 3 A & A Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com...
Page 5
• Add Left Front [B] and Right Front [C] Legs to the Side Braces [F] with two M8 Socket Head Bolts using the included 5mm Hex Key to lightly hand tighten (FIG 6). FIG. 5 FIG. 6 To order parts and supplies: 800.343.9353 >> eastwood.com...
Page 6
• Next, place M8 Socket Head Bolts through the side of each Front Leg [B] & [C], Side Fence [J] and Top [G] then secure with M8 Self-Locking Nuts (FIG 9). Finger tighten only. FIG. 9 Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com...
• Occasionally inspect all components for potential damage and proper alignment. Check all hardware for tightness • DO NOT use if damage is discovered. To order parts and supplies: 800.343.9353 >> eastwood.com...