Advertisement
FRAME ASSEMBLY
NOTE: When assembling components in the next stages, it is impor-
tant to only hand tighten all hardware to allow for alignment.
• Begin by setting the two Rear Legs [A] (having 8 holes &
2 notches) on a soft surface with the outer corners upward
(FIG 3).
• Place the long, Rear Brace [E] with the Threaded Inserts
aligned with the two punched holes in the rear face of each
Rear Leg [3]. Secure with four M8 Socket Head bolts using
the included 5mm Hex Key to lightly hand tighten.
• Flip Rear Leg and Brace [A] & [E] assembly with outside
corners down (FIG 4).
• Set the short, Side Braces [F] with the Threaded Inserts
aligned with the two punched holes in the side face of each
Rear Leg [A]. Secure with four M8 x 15 Socket Head Bolts per
corner using the included 5mm Hex Key to lightly hand tighten
(FIG 5).
• Add Left Front [B] and Right Front [C] Legs to the Side Braces
[F] with two M8 Socket Head Bolts using the included 5mm
Hex Key to lightly hand tighten (FIG 6).
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 4
" " " "
FIG. 5
A
FIG. 6
C
A
E
E
F
F
E
A
5
Advertisement
