Connecting The Main Speakers - Yamaha VS-10 Owner's Manual

Connecting the Main Speakers

Connect the main speakers to the control center.
Note
• Do not connect any speakers to the speaker terminals on the control center except for the supplied main speakers (NX-VS10M). Damage
may result if a different speaker is connected.
Right main speaker (Rear panel)
Bare wire
Tab
Control center (Rear panel)
VIDEO SIGNAL
MONITOR
OUT
+ –
DO NOT CONNECT THIS UNIT TO
SPEAKERS OTHER THAN NX-VS10M
MAIN SPEAKERS
OUT
DIGITAL 1 VIDEO 1 TV
SUBWOOFER
(V/PCM)
INPUT
CAUTIONS
• Do not let the bare speaker wire touch each other and do not let them touch any metal part of the speakers. This could
damage the speakers.
• Do not mistakenly connect positive (+) to negative (–) or vice versa when connecting speaker cords.
• Insert the speaker cords securely so that positive (+) and negative (–) do not short. The speaker may not output any
sound or may output noise, causing damage to the speakers, if speaker cords are not inserted securely.
• Only insert the bare wire portion of the speaker cords into the holes. Sound will not be output if you insert as far as the
plastic insulation part of the cord.
• Secure the speaker cords so that they will not catch on hands or feet.
2
3
1
+ – –
DO NOT CONNECT THIS UNIT TO
SPEAKERS OTHER THAN NX-VS10M
MAIN SPEAKERS
– +
MARK
SYSTEM
CONNECTOR
Left main speaker (Rear panel)
1
Open the tab.
2
Insert the bare wire of the speaker cord into
the hole.
3
Return the tab until it clicks.
• Connect the white cord to the + terminal (red), and the
+
black cord to the – terminal (black).
• Once connected, pull gently on the speaker cords to
check that they are connected securely.
0.8A MAX. 120V
60Hz 100W MAX.
AC OUTLET
CONNECTIONS
13