Specifications - Yamaha RX-V392 Owner's Manual

SPECIFICATIONS

AUDIO SECTION
Minimum RMS Output Power per Channel
Main L, R
8 ohms, 20 Hz to 20 kHz, 0.04% THD
< >
RX-V492
[U.S.A. and Canada models]
..............................................70W + 70W
[Australia and General models]
..............................................65W + 65W
< >
RX-V392 ............................50W + 50W
Center
8 ohms, 1 kHz, 0.09% THD
< >
RX-V492
[U.S.A. and Canada models] ............70W
[Australia and General models] ........65W
< >
RX-V392 ........................................50W
Rear
8 ohms, 1 kHz, 0.7% THD..........20W + 20W
Maximum Power [General model only]
(8 ohms, 1 kHz, 10% THD)
Main L, R
< >
RX-V492 ........................100W + 100W
< >
RX-V392 ............................75W + 75W
Center
< >
RX-V492 ........................100W + 100W
< >
RX-V392 ............................75W + 75W
Rear ...........................................30W + 30W
Dynamic Power per Channel
(by IHF Dynamic Headroom measuring
method)
< >
RX-V492
[U.S.A. and Canada models]
8/6/4/2 ohms ..............100/120/150/175W
[Australia and General models]
8/6/4/2 ohms ................95/115/145/165W
< >
RX-V392
[U.S.A. and Canada models]
8/6/4/2 ohms ..................80/95/120/140W
[Australia and General models]
8/6/4/2 ohms ................80/100/120/135W
Dynamic Headroom (8 ohms)
[U.S.A. and Canada models only]
< >
RX-V492 ...................................1.55 dB
< >
RX-V392 ...................................2.04 dB
Power Band Width
< >
RX-V492
8 ohms, 30W, 0.1% THD
..........................................10 Hz to 50 kHz
< >
RX-V392
8 ohms, 25W, 0.1% THD
..........................................10 Hz to 50 kHz
Damping Factor (SPEAKERS A)
8 ohms, 20 Hz to 20 kHz .............80 or more
36
Input Sensitivity/Impedance
PHONO MM .....................2.5 mV/47 k-ohms
CD/TAPE/DVD·LD/TV·DBS/VCR
........................................150 mV/47 k-ohms
Maximum Input Signal
PHONO MM
1 kHz, 0.5% THD............................100 mV
CD/TAPE/DVD·LD/TV·DBS//VCR
(EFFECT OFF)
1 kHz, 0.5% THD.................................2.5V
Output Level/Impedance
REC OUT .......................150 mV/2.5 k-ohms
SUBWOOFER (EFFECT OFF)
...............................................3.5V/1 k-ohms
Headphone Jack Rated Output/Impedance
Output Level (8 ohms, 0.04% THD).....0.45V
Impedance.....................................330 ohms
Frequency Response (20 Hz to 20 kHz)
CD/TAPE/DVD·LD/TV·DBS//VCR
........................................................0±0.5 dB
RIAA Equalization Deviation
PHONO MM....................................0±0.5 dB
Total Harmonic Distortion (20 Hz to 20 kHz)
PHONO MM to REC OUT
1V .....................................................0.02%
CD/TAPE/DVD·LD/TV·DBS/VCR to SP OUT
30W/8 ohms .....................................0.03%
Signal-to-Noise Ratio (IHF-A Network)
PHONO MM to REC OUT
(5 mV Input Shorted) ...........................80 dB
CD/TAPE/DVD·LD/TV·DBS/VCR to SP OUT
(Shorted) ..............................................93 dB
Residual Noise (IHF-A Network)
MAIN L/R ...........................................140 V
Channel Separation
(Vol. –30 dB, EFFECT OFF)
PHONO MM
(Input Shorted, 1 kHz)
..........................................................60 dB
CD/TAPE/DVD·LD/TV·DBS/VCR
(Input 5.1 k-ohms Terminated,
1 kHz) ................................................60 dB
Tone Control Characteristics
BASS: Boost/cut ................±10 dB (50 Hz)
Turnover Frequency .........(350 Hz)
TREBLE: Boost/cut...........±10 dB (20 kHz)
Turnover Frequency.....(3.5 kHz)
Gain Tracking Error (0 to –60 dB) ............3 dB
VIDEO SECTION
Video Signal Type
[U.S.A., Canada and General models]
.....................................................NTSC/PAL
[Australia model].....................................PAL
Video Signal Level..................1 Vp-p/75 ohms
Maximum Input Level............1.5 Vp-p or more
Signal-to-Noise Ratio ................50 dB or more
Monitor Out Frequency Response
.....................................5 Hz to 10 MHz, –3 dB
FM SECTION
Tuning Range
[U.S.A. and Canada models]
..........................................87.5 to 107.9 MHz
[Australia and General models]
..........................................87.5 to 108.0 MHz
50 dB Quieting Sensitivity (IHF, 75 ohms)
[U.S.A., Canada and General models only]
Mono...............................1.55 V (15.1 dBf)
Stereo ................................21 V (37.7 dBf)
Usable Sensitivity
DIN, Mono (S/N 26 dB)
[Australia model] ...............................0.9 V
DIN, Stereo (S/N 46 dB)
[Australia model] ................................24 V
Image Response Ratio
[U.S.A., Canada and General models]
..............................................................45 dB
[Australia model] ...................................80 dB
IF Response Ratio
[U.S.A., Canada and General models]
.............................................................70 dB
[Australia model] ..................................80 dB
Spurious Response Ratio ........................70 dB
AM Suppression Ratio .............................55 dB
Capture Ratio..........................................1.5 dB