Recording - Yamaha HTR-5990 Owner's Manual

Recording adjustments and other operations are
performed from the recording components. Refer to the
operation instructions for those components.
MAIN ZONE
ZONE 2 ZONE 3
ON/OFF
ON/OFF ON/OFF
MASTER
PRESET/TUNING FM/AM A/B/C/D/E
ON :OFF
SEARCH MODE CATEGORY
EDIT
OPTIMIZER MIC
PROGRAM
PHONES SPEAKERS
A B PURE DIRECT STRAIGHT TONE CONTROL
EFFECT
SILENT CINEMA
1
1
Turn on the power of this unit and all
connected components.
See page 28 for details.
2
Rotate the INPUT selector on the front panel
(or set AMP/SOURCE/TV to SOURCE and
then press one of the input selector buttons)
to select the input source you want to record
from.
Front panel
AMP
SOURCE
TV
Remote control
3
Start playback (or select a broadcast station)
on the source component.
4
Start recording on the recording component.

RECORDING

(U.S.A. model)
VOLUME
l PRESET/TUNING/CH h
MEMORY TUNING MODE
DISPLAY
MAN'L/AUTO FM AUTO/MAN'L
INPUT
VIDEO AUX
AUDIO SELECT MULTI CH ZONE CONTROL
INPUT
S VIDEO VIDEO L AUDIO R OPTICAL
2
INPUT
or
A XM AUDIO SEL SLEEP
PHONO TUNER CD MULTI CH IN
V-AUX CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR2 DVD
y
Do a test recording before you start an actual recording.
Notes
• The source you record and the source sent to Zone 2 can be
selected separately.
• When this unit is in the standby mode, you cannot record from
other components connected to this unit.
• The settings for TONE CONTROL (see page 36), VOLUME,
SP LEVEL (see page 78) and programs do not affect recorded
material.
• A source connected to the MULTI CH INPUT jacks of this unit
cannot be recorded.
• S-video and composite video signals pass independently
through the video circuits of this unit. Therefore, when
recording or dubbing video signals, if your video source
component is connected to provide only an S-video or only a
composite video signal, you can record only an S-video or only
a composite video signal to your VCR.
• Digital signals input at the DIGITAL INPUT jacks are not
output at the analog AUDIO OUT L/R jacks for recording.
Likewise, analog signals input at the AUDIO IN L/R jacks are
not output at the DIGITAL OUTPUT jack. Therefore, if your
source component is connected to provide only digital or analog
signals, you can only record digital or analog signals.
• A given input source is not output on the same OUT (REC)
channel. For example, the signal input at VCR 1 IN is not
output at VCR 1 OUT.
• Check the copyright laws in your country to record from
records, CDs, radio, etc. Recording of copyrighted material may
infringe copyright laws.
• Some HDMI audio signals input at the HDMI IN 1 or HDMI IN
2 jack of this unit may not be output at the DIGITAL AUDIO
(OPTICAL) jacks depending on the type of those HDMI audio
signals.
If you play back a video source that uses scrambled or
encoded signals to prevent it from being dubbed, the
picture itself may be disturbed due to those signals.
■ Notes on the DTS software
The DTS signal is a digital bitstream. Attempting to
digitally record the DTS bitstream will result in noise
being recorded. Therefore, if you want to use this unit to
record sources that have DTS signals recorded on them,
the following considerations and adjustments need to be
made.
For DVDs and CDs encoded in DTS, when your player is
compatible with the DTS format, follow its operation
instructions to make a setting so that the analog signal will
be output from the player.
RECORDING
43