WORK
Installing the battery
3.7
Opening filler cap
3.8
Closing filler cap
3.9
–
Switch off all power-consuming components and switch off the engine.
–
Remove the rear fender. (
–
Disconnect the minus (negative) cable of the battery to avoid damage to the vehi-
cle's electronics.
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the generator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove the lid
Charge the battery according to the instructions
–
Switch off the charger after charging. Disconnect the battery.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
vehicle is not in use.
–
Install the rear fender. (
100087-10
–
Place the battery in the battery holder.
4Ah battery (YTX5L-BS)
–
Reconnect rubber band
–
Attach the positive (plus) cable and replace the plus pole cover
–
Connect the negative (minus) cable
–
Install the rear fender. (
300279-11
–
Press release button
100012-10
–
Replace the filler cap and turn clockwise until the release button
–
Check the fuel tank breather
»
If the fuel tank breather is at an angle or loose:
–
Correctly mount the fuel tank breather.
100012-11
p. 5)
.
3 months
p. 6)
.
of the battery.
p. 6)
, turn filler cap counterclockwise and lift it free.
to ensure it is properly seated.
7
on the battery casing.
.
locks in place.