Yamaha CinemaStation DVR-S150 Owner's Manual page 87

Troubleshooting
Problem
A digital equipment or high-
frequency equipment
produces noises
The Set Menu configurations
have been cleared
The volume does not
increase or sounds are
distorted
Recording sounds does not
reflect the sound field effect
settings
Sound played on the
CinemaStation cannot be
recorded with an external
recorder
Sounds played on the AV
equipment connected to the
CinemaStation cannot be
recorded with external
recording equipment
The CinemaStation does not
operate properly
A digital equipment or high-
frequency equipment
produces noises
The Set Menu
configurations have been
cleared
82
Cause
The CinemaStation may be placed
close to the digital equipment or
high-frequency equipment.
The power to the CinemaStation may
be lost more than a week.
The power of the component
connected to a CinemaStation's
output jack may be turned off.
The sound field effects are not
available for recording.
You may be trying to make a digital
recording with an analog source, or
analog recording with a digital
source.
The recording equipment may be
connected to the CinemaStation with
an analog connection.
Either the AV equipment or recording
equipment may be connected to the
CinemaStation with a digital
connection.
The CinemaStation may receive a
strong electrical shock, such as from
a lightening bolt or excessive static
electricity, or drop in power supply.
The CinemaStation may be placed
close to digital equipment or high-
frequency equipment.
The power to the CinemaStation may
be lost more than a week.
Solution
Place the CinemaStation further away
from such equipment.
Make sure the power cable is plugged
into the outlet firmly, then configure the
Set Menu settings again. (page 75)
Turn on the power of the component
connected to a CinemaStation's output
jack.
Use proper audio sources.
Connect them with a digital connection.
(page 16)
Connect those equipment to the
CinemaStation with analog
connections. (page 16)
Set the CinemaStation to the Standby
mode, then disconnect the power cable.
Wait for about 30 seconds, then connect
the power cable and turn on the
CinemaStation.
Place the CinemaStation further away
from such equipment.
Make sure the power cable is plugged
into the outlet firmly, then configure the
Set Menu settings again. (page 75)