Controlling External Components; Setting Remote Control Codes - Yamaha CinemaStation DVR-S150 Owner's Manual

CONTROLLING EXTERNAL COMPONENTS

In addition to controlling this unit, you can operate your TV, VCR, CD recorder or MD recorder with the CinemaStation
remote control by selecting the appropriate remote control code (refer to "LIST OF REMOTE CONTROL CODES" at
the end of this manual).
Note
Depending on the product, the CinemaStation remote control may not be able to operate the external component. In this case, use the
remote control supplied with the product.

Setting remote control codes

The TV button selects a remote control code for a TV. The
VCR button selects a remote control code for a VCR, CD
recorder, or MD recorder.
STANDBY/ON
POWER
TV
AUDIO ANGLE SUBTITLE
SURROUND SELECT MATRIX 6.1 STEREO
REPEAT A-B
NIGHT
SW CENTER SURR
SET MENU
SHIFT
TV INPUT
TV CH
A B C D E
SLEEP
PRESET PRESET
PTY SEEK
FREQ/RDS MODE START
ON SCREEN MENU
START
YPAO
CH
ENTER
RETURN
STATUS
TEST
ON/OFF
TV VOL VOLUME
MUTE
AMP
DVD/CD VIDEO
VCR
TUNER
MOVIE MUSIC SPORTS GAME
CINEMA
72
Controlling External Components
TV
Number
buttons
SHIFT
CH
VCR
1
While holding down SHIFT
then while still holding down SHIFT, press
the number buttons to enter the three-digit
remote control code (refer to "LIST OF
REMOTE CONTROL CODES" at the end of
this manual) for the manufacturer of your
component.
If the setting is successful, the message "Code Set
OK" appears in the CinemaStation display.
If the setting fails, the message "Code Set NG"
appears. In this case, perform this step again.
The factory settings are "299" (YAMAHA TV) for
TV and "399" (YAMAHA VCR) for VCR.
2
Refer to "Available operations" (page 73) and
try one of the button operations for your
component to check that the setting is
working properly.
If the button operation does not work properly, the
remote control code may be incorrect. In this case,
perform step 1 again.
Notes
• Even if you set a remote control code, it will be cleared about
two minutes after the remote control batteries run out. In this
case, store remote control codes again after replacing the
batteries. (Be careful not to press the remote control buttons
while replacing the batteries. Doing so may clear the settings.)
• Depending on the product, the CinemaStation remote control
may not be able to operate the external component. In this case,
use the remote control supplied with the product.
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
press TV or VCR,
,