Hydraulic Ports - Bosch Rexroth Hägglunds CA Series Installation And Maintenance Manual

Bosch Rexroth Mellansel AB, Installation and maintenance manual, Hägglunds CA 10 - CA 40, RE 15354-WA/04.2015

7.3.5 Hydraulic ports

When using (thick wall) piping and in frequent reversal drives, it is recommended
to fit flexible hoses between the motor and piping to avoid damage due to vibration
and to simplify installation of the motor. The length of the hoses should be kept fairly
short.
Fig. 15: Connection side of the motor
Table 13: Ports
Connection Description
A1 Main connection
C1 Main connection
Alternative main
A2
connection
Alternative main
C2
connection
D1 Drain connection
Alternative drain
D2
connection
Dimension Remarks
Normally plugged at delivery.
If A is used as the inlet, the motor
G 1"
shaft rotates counter clockwise,
viewed from the motor shaft side.
Normally plugged at delivery.
If C is used as the inlet, the motor
G 1"
shaft rotates clockwise, viewed from
the motor shaft side.
G 1" Normally plugged at delivery.
G 1" Normally plugged at delivery.
G 1/2" Normally plugged at delivery.
G 1/2" Normally plugged at delivery.
Installation 29/52
DD00068761