Advertisement
Install the NI-DNET Software Before the Hardware
Before installing the NI-DNET software, first log on as
user with Administrator privileges. The NI-DNET setup program must have
Administrator privileges because the program modifies the configuration registry
of your system.
Complete the following steps.
1. Insert the NI-DNET Software for Windows CD into your CD-ROM drive.
The installer launches if your CD-ROM drive plays data CDs automatically.
If the installer doesn't launch automatically, navigate to the CD using
Windows Explorer and launch the
for Windows CD.
2. The Installation Wizard guides you through the necessary steps to install the
NI-DNET software. You can go back and change values where appropriate by
clicking Back. You can exit the setup where appropriate by clicking Cancel.
3. If you have LabVIEW Real-Time (RT) installed on your system, download
the NI-DNET driver support for your Real-Time PXI controller. Launch
Measurement & Automation Explorer (MAX) and follow the online help to
download NI-DNET Real-Time components to your Real-Time PXI
controller.
4. Power off your computer when the setup is complete.
5. Proceed to the
NI-DNET Hardware and Software for Windows
Install the CAN Hardware
file from your NI-DNET Software
autorun
section.
2
Administrator
or as a
ni.com
Advertisement
