Controlling Zone 2 Or Zone 3 - Yamaha RX-V3900 Owner's Manual

■ Using TRIGGER OUT jacks for Zone 2 and Zone 3
This unit is equipped with two TRIGGER OUT jacks. You can turn on and off the component corresponding to the
selection of the input source of the desired zone or turning on and off the desired zone by configuring the "Trigger
Output" settings (page 100).
Trigger in
Projector (etc.) in the
main zone
After the connections, turn on this unit and set the
speaker terminal assignments with "Zone SP Assign"
(page 96).

Controlling Zone 2 or Zone 3

You can select the zone you want to control by using the
control buttons on the front panel or on the remote control.
■ Basic operation
Front panel operations
Press O ZONE 2 or O ZONE 3 on the front
1
panel to individually turn on or off Zone 2 or
Zone 3.
Press O ZONE CONTROLS on the front
2
panel repeatedly to select the zone you want
to control.
Each time you press O ZONE CONTROLS, the
front panel display changes as shown below, and the
indicator for the currently selected zone flashes for
approximately 10 seconds. However, no indicator
flashes when the main zone is selected.
ZONE2
No indicator flashes
when the main zone is selected.
ZONE2
Controls the Zone 2 amplifier or tuner functions.
ZONE3
Controls the Zone 3 amplifier or tuner functions.
This unit
1 2
TRIGGER OUT
ZONE3
Power amplifier (etc.)
Zone 2 (etc.)
y
You must complete this step within 10 seconds while the
selected zone flashes in the front panel display. Otherwise,
the currently selected zone mode is automatically
canceled.
3
Perform the desired operation in the selected
zone (page 120).
y
To turn off the desired zone, press OZONE 2 or
OZONE 3 again.
Remote control operations
Press H ZONE repeatedly to select the zone
1
you want to control.
"MAIN", "ZONE 2", or "ZONE 3" indicator appears
in the display window (4) on the remote control.
ZONE 2 ZONE 3
(Zone 2) (Zone 3)
2
Press EPOWER to turn on the selected
zone.
3
Perform the desired operation in the selected
zone (page 120).
y
To turn off the desired zone, press DSTANDBY.
Using multi-zone configuration
Trigger in
MAIN
(Main zone)
119
En