Troubleshooting - Klarstein Glacial Manual

EN
26
• Clean the ice storage bin once weekly.
• Open the ice maker door and remove all the ice cubes.
• Use a mild detergent to clean the inner wall of the ice storage bin and rinse with
water.
• Wipe the inner wall with a cloth dampened with a mild detergent, rinse with water,
and finally wipe the inner surface with another piece of clean cloth.
Inlet valve cleaning
• Unplug the power plug or disconnect the power supply and turn off the faucet.
• Unscrew the inlet pipe and water valve connections.
• Gently pull out the filter on the inlet valve by hand.
• Brush the filter with a brush and rinse with water.
• Put the filter back into the water valve, then connect the inlet pipe, open the faucet
and check for water leakage.

TROUBLESHOOTING

Fault Inspection
Ice maker is Power switch
unable to start.
Power plug
Control panel fuse
Ice storage bin
Power supply
Wasserhahn
Inlet valve
Cause Solution
In the OFF Turn the power
position switch to the ON
position.
Not plugged into Plug the mains
the socket plug into the
socket.
Faulty or Check and
damaged replace
The ice storage Remove the ice
bin is full and the or remove the ice
ice is pressed from the blades of
against the blades the evaporator.
of the evaporator.
No electricity or Contact your
voltage is too low electricity supplier.
No water or Increase the water
water pressure is pressure.
too low
The filter is Clean the filter or
clogged or the replace the inlet
water valve is valve.
faulty.