Basic Operations - Yamaha R-V702 R-V502 Owner's Manual

TO PLAY A SOURCE
1
28
40
60
Set to the "
2
Turn the power on.
3
Select the desired input source by using the input
selector buttons.
(For video sources, turn the TV/monitor ON.)
TUNER PHONO
* The name of the selected input source will appear on
the display.
4
Select the main speakers to be used.
SPEAKERS
* If you use two main speaker systems, press both the A
and B switches.

BASIC OPERATIONS

2
4
VOLUME
l6
20 l2
8
4
2
0
–dB
∞
" position.
POWER
CD
A B
ON OFF
3
7
5
Play the source. (For detailed information on the
tuning operation, refer to page 26.)
6
Adjust to the desired output level.
7
If desired, adjust the BASS, TREBLE and BALANCE
controls (refer to page 25), and use the digital sound
field processor. (Refer to page 31.)
Notes on using the input selector buttons
Note that pressing on each input selector button selects
the source which is connected to the corresponding input
terminals on the rear panel.
The selection of TAPE (MD) MONITOR cannot be
canceled by pressing another input selector button. To
cancel it, press TAPE (MD) MONITOR again so that
"TAPE MON" disappears from the display.
When you select a button other than TAPE (MD)
MONITOR, make sure that "TAPE MON" is not illuminated
on the display.
If you select the input selector button for a video source
without canceling the selection of TAPE (MD) MONITOR,
the playback result will be the video image from the video
source and the sound from the audio tape (or MD etc.).
Once you play a video source, its video image will not be
interrupted even if the input selector button for an audio
source is selected.
To turn off the power
Press the POWER switch again.
1, 6
l6
20 l2
28 8
40 4
2
60
0
–dB
VOLUME
l6
20
l2
28 8
4
40
2
60
0
–dB
23