DS-K1100 Series Card Readers Connect
Title:
to DS-K2600 Series Access Controllers
by Wiegand
Product:
Access Control Device
4.
Please check the rear panel of card reader and unscrew it, you could find DIP switch module;
The No. of DIP switch from left to right is 1~8:
Description of DIP Switch:
No.
1~4
5
6
7
8
5.
We suggest customers choose RVVP cable for card reader wiring;
Step 1: DIP Switch
Please set the DIP switch firstly before connecting the card reader, please check the table below:
If customers choose standard W34 protocol, the binary value of the card reader should be
If customers choose standard W26 protocol, the binary value of the card reader should be
Version:
Page:
Icon
Description
Address of RS485
Read card No. or file in card(Reserved)
Wiegand protocol or RS-485 protocol
Wiegand Protocol
(available when No. 6 is 1)
Matched Resistance(Reserved)
(available for RS-485 protocol)
v1.0
Date:
6/21/2017
2 of 5
Description
Represent 1 in binary mode
Represent 0 in binary mode
DIP Switch Status
1: 1
0: 0
1: read file in card
0: read card No.
1: Wiegand protocol
0: RS-485 protocol.
1: Wiegand protocol of 26-bit;
0: Wiegand protocol of 34-bit.
1: Enable;
0: Disable.
DIP Switch Status
Reader
0000 0100
Wiegand 34 Protocol
0000 0110
Wiegand 26 Protocol
0000 0100;
0000 0110;