Board 7265 (Irig-B Analog Output); Board 7515 (Grid-Time) - hopf Elektronik GmbH 7001GPS Technical Manual

Satellite clock system with control board 7020gps
Table of Contents

Advertisement

K
EYPAD
1. Input frame: (Example for LAN board no.1)
1 CB: 00000010 IP: 192.075.068.005
NEW
>_
After input of the LAN board number followed by "ENT", the selection and evaluation of the
data of the corresponding board takes place. These are shown into the first line of the dis-
st
play (1
input frame), if the board indicated is available within the system
In this section control byte (CB) and IP address (IP) can be entered.
Control byte input: for the input only the figures"0" und "1" are permissible; the input
is only bit by bit. The significance of the individual bits can be found in the technical
board description. The input of the control byte is completed with "ENT".
Input of the IP address: this is entered in 4 groups, separated by a point ( . ), with 3
decimal figures between 0...255.
The input must be in 3 digits (e.g.: 9
After confirmation of the IP address with "ENT" then there is a change to the 2nd section of
the parameter input.
2. Input frame: (Example for LAN board no.:1)
1 NM: 04 GW: 192.075.068.055
NEW
>_
In this section the network mask (NM) and Gateway address (GW) are entered.
Input of the network mask: this is in 2 digits in the range 00..32. Input must be
completed with "ENT".
Input of the gateway address: this is done in the same way as for the IP address.
The input must be completed with "ENT".

4.4.3 BOARD 7265 (IRIG-B ANALOG OUTPUT)

This function is not yet implemented.

4.4.4 BOARD 7515 (GRID-TIME)

Selection frame:
BOARD 7515 (GRID-TIME) Y/N
With this function the network frequency analysis data can be called up by the 7515 network
analysis board. Further information can be found in the technical description to 7515.
1. Input frame:
->_ NT:
ST:
32 / 44
hopf Elektronik GmbH
Nottebohmstr. 41 • D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: info@hopf.com
>
.
>
.
.
.
After the final input the transmission to the LAN board must be confirmed
with "ENT"er, in order to set off a re-initialisation.
:
:
dT:
:
:
:
F:
,
.
.
<
009).
<
:
,
Hz IN (R)->
7001GPS Satellite Clock System - V08.00

Advertisement

Table of Contents
loading

Table of Contents