Graco A Series Instructions-Parts List Manual page 19

(1) on the outlet valve housing (2) and install the
twelve screws (9) and lockwashers (8) loosely.
19. Tighten the inside four screws (9) oppositely and
evenly to 3 N•m (27 in-lb) to balance the load on the
valves. Then tighten all twelve screws oppositely
and evenly to 24-27 N•m (18-20 ft-lb). See F
20. Lubricate the throat packings and glands. Install one
male gland (30†) in the throat cartridge (45), then
seven v-packings with the lips facing down: one
UHMWPE (27†), one leather (28†), UHMWPE,
leather, UHMWPE, leather, UHMWPE. Install the
female gland (29†). Install three v-packings with the
3A2023C
lips facing up: UHMWPE, leather, UHMWPE. Install
the other male gland (30†).
21. Torque the cartridge (45) to 129-135 N•m (95-100
ft-lb).
22. Reinstall the coupling nut and collars on the piston
. 19.
IG
rod (19). Fill the cavity in the bottom of the motor
shaft with grease. Reconnect the lower to the motor
as described in your separate pump manual.
23. Fill the cavity in the bottom of the motor shaft with
grease. Reconnect the lower to the motor as
described in your separate pump manual.
Repair - Model 24J090
19