Panasonic KX-TGH260BX Operating Instructions Manual page 63

Problem
I cannot hear a dial tone.
I cannot use the Smart
Function Key even if the
indicator is flashing
slowly.
The base unit beeps.
Menu list
Problem
The display is in a
language I cannot read.
I cannot activate the eco
mode.
I cannot register a handset
to a base unit.
Battery recharge
Problem
The handset beeps and/or
flashes.
I fully charged the
batteries, but
– still flashes or
– the operating time
seems to be shorter.
Cause/solution
R Make sure that you are using the supplied telephone line cord.
Your old telephone line cord may have a different wiring
configuration.
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working
telephone operates properly, contact our service personnel to
have the unit repaired. If the working telephone does not
operate properly, contact your service provider/telephone
company.
R Another unit is in use. Wait and try again later.
R The key lock feature is turned on. Turn it off (page 24).
R New messages have been recorded. Listen to the new
messages (page 53).
Cause/solution
R Change the display language (page 13).
R You cannot set eco mode when you set the repeater mode
"On". If required, set the repeater mode to "Off" (page 45).
R The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 45).
R You entered the wrong PIN. If you forget your PIN, contact an
authorised service centre.
Cause/solution
R Battery charge is low. Fully charge the batteries (page 9).
R Clean the battery ends (
a dry cloth and charge again.
R It is time to replace the batteries (page 8).
Useful Information
, ) and the charge contacts with
63