Intercom; Key Lock; Power Back-Up Operation For Landline - Panasonic KX-TGH260BX Operating Instructions Manual

Making/Answering Calls
3
To answer the 2nd call:
Press M N or M N while the 2nd call is
being received.
4
To hang up the 2nd call and return to the
1st call (mobile call), press M
*1
press M N .
*1 If you press M N and the selection list is
displayed, select the desired mobile line
and press MOKN.

Intercom

Intercom calls can be made between
handsets.
Note:
R When paging the handset, the paged
handset beeps for 1 minute.
R If you receive an outside call while talking
on the intercom, the interrupt tone sounds
(page 35). To answer the call, press
M N, then press the corresponding line
key.
Making an intercom call
1
M N (right soft key) a M
2
MbN: Select the desired unit. a MOKN
3
When you finish talking, press M
Answering an intercom call
1
Press M N to answer the page.
2
When you finish talking, press M
Using the Smart Function Key
Press M N to answer the page.
Turning auto intercom on/off
This feature allows the handset to answer
intercom calls automatically when it is called.
You do not need to press M
feature is set to "On", the monitoring handset
for the baby monitor feature (page 43) will
24
N, then
N
N.
N.
N. When this
also answer baby monitor calls automatically.
The default setting is "Off".
1
M N (right soft key) #273
2
MbN: Select the desired setting. a MOKN
a M N

Key lock

The handset can be locked so that no calls or
settings can be made. Incoming calls can be
answered, but all other functions are disabled
while key lock is on.
To turn key lock on, press M
for about 3 seconds.
R To turn key lock off, press M
key) for about 3 seconds.
Note:
R Calls to emergency numbers cannot be
made until key lock is turned off.
Power back-up operation
for landline
When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power back-up mode). This allows
you to make and receive landline calls using a
handset during a power failure. The base unit
will not perform any other functions. However,
some functions such as Caller ID and
phonebook are available only when using a
handset other than the handset supplying
power to the base unit. You can program
"Power failure" and the default setting is
"Auto" (page 37).
Important:
R If a handset is not placed on the base unit
when a power failure occurs, "Base no
power Press
pressing M N on the handset, place it on
the base unit to start power back-up mode.
R Power back-up mode will not work if the
battery level of the power supplying
handset is /
N (right soft key)
N (right soft
" is displayed. After
.