HomeMatic HmIP-WLAN-HAP Mounting Instruction And Operating Manual page 50

Restore factory settings
6 Restore factory settings
The factory settings of your Homematic IP WLAN Access
Point and of the entire installation can be restored. The
operations distinguish as follows:
• Resetting the WLAN Access Point:
Here, only the factory settings of the WLAN Ac-
cess Point will be restored. The entire installation
will not be deleted.
• Resetting and deleting the entire installation:
Here, the entire installation is reset. Afterwards,
the app has to be uninstalled and reinstalled.
The factory settings of your single Homematic
IP devices have to be restored to enable them to
be connected again.
6.1 Resetting the Homematic IP WLAN
Access Points
To restore the factory settings of the Homematic IP
WLAN Access Point, proceed as follows:
• Disconnect the WLAN Access Point from the
power supply. Therefore, unplug the USB mains
adapter.
• Plug-in the USB mains adapter again and press
and hold down the system button (A) for 4s, until
the LED (A) will quickly start flashing orange.
• Release the system button again.
• Press and hold down the system button again for
50