Installing Optional Scanner Mount; Installing Tablet Holder Onto 105 Cart - Jaco Ultralite 100 Series User Manual

Installing Optional Scanner Mount

If you have ordered a Scanner Holder option, you may need to install this onto the Cart. Remove the work
surface as shown above and place the Scanner Holder so that the (2) threaded studs will insert into the hole at
on the rear surface. Left or Right side mount Scanner Holders are available. A right side mount is shown
below for reference.

Installing Tablet Holder onto 105 Cart

The Tablet Holder and Arm are shipped with the Cart but not attached due to the shipping container. Before
attaching the arm, first remove the rear storage cup. Remove the (2) Phillips Head screws and slide the cup
upward to remove.
With the Cart Top removed (see instruction on page 6) use the (4) Phillips Head Screws included to attach the
stand to the rear surface of the Cart. Make sure to tighten all (4) screws.
Attach the rear cup to the Tablet Arm, slide the cup down into position and attach using the (2) Phillips Head
screws removed above. This storage cup can be use to hold a mouse if one is needed on the Mobile Cart.
8