Installing And Locking Your Tablet - Jaco Ultralite 100 Series User Manual

Installing and locking your Tablet:

To install your Tablet into the JACO Tablet Holder, place the bottom of the Tablet into the bottom catch flanges
and push the Tablet back into the holder. For the style of Locking Tablet Holder shown below, rotate the
combination lock clockwise while holding the Tablet in the holder. A locking tab will lock the Tablet into position.
The default combination for the type of locking holder is 0,0,0.
You can easily change the default combination. With the lock in the 0, 0, 0 position, use a paperclip end to press
and hold the reset pin that is located on the edge of the combination lock as shown below. With this pin
depressed, change the combination and then release the pin.
Remember that all combinations need to be recorded. If the combination is changed and you forget the
new number, the only way to remove your Tablet will be to remove the (4) Torx Head screws that hold the locking
assembly to the holder. It is your responsibility to record all combinations. JACO does not supply Tools for
removing Tablets.
9