Table of Contents
Advertisement
Basic Mobile Cart Integration & Operation
Unpacking & Assembly:
Your JACO Mobile Cart may be delivered stacked with one container on top of another. Please use caution
when removing the top Cart for unpacking. This is a two person lift and the top Cart must be placed on the
ground before unpacking. Once unpacked, there will be minimal assembly required depending on the Mobile
Cart model and options you have ordered. Due to the shipping container, the LCD and Stand (for LCD Carts)
and the optional Scanner Mounts, are not able to be attached at our factory.
Changing the Height Position:
Your JACO Mobile Cart is height adjustable for proper ergonomics when used in a standing or sitting position.
To change the height, place the palms of your hands on the left and right sides of the work surface and on the
right side, squeeze the release lever by pulling it upward. This will free the internal locking piston and will allow
you to pull the Cart top up or push it down and offers a total of 16" of travel. Release the lever when the cart is
in the desired position.
Installing your computer or laptop:
To install your PC or Laptop, unlock both key-locks at the rear of the top assembly as shown in the photo
below. Both locks must be opened before the top work surface can be pulled forward and removed from
the Cart. Once the work surface is removed, the open bay area (shown below) is available for installing
your computer or laptop. Route all cables needed for proper operation before installing the work surface
and locking in place for security. If using a laptop computer, simply open and allow the display to protrude
through the opening in the work surface.
7
Advertisement
Table of Contents
