Honeywell LYNXDM-GSM Installation And Setup Manual page 4

8. Connect the 4-wire communication cable connector to the LRR/IP communications port on the LYNXR-I
(refer to figure 4).
9. Make the wiring connections to the LYNXR-I in accordance with the LYNXR-I or LYNXR-ISIA
Installation Instructions.
10. Route the wires as shown in Figure 4.
WALL MOUNT
FRONT CASE AND
LYNXR-I REAR CASE
LOCKING
TABS
Figure 2 – LYNXR-I Series Control
TURN OVER
WALL MOUNT
REAR CASE
Figure 3 – LYNXDM-GSM/LYNXDM-IGSM Assembly
LOCKING TABS
RED WIRE
MARKING
DISCONNECT
THIS END ONLY!
HOOKS
TABS
- 4 -
LOCKING
TABS
07000-003-V1
09004-013-V0