Honeywell LYNXDM-GSM Installation And Setup Manual page 5

COMMUNICATIONS
INCOMING
POWER,
TELEPHONE
& INTERNET
LINES
WIRE TIE LOOP
NETWORK
CONNECTIVITY
LED DISPLAY
(LYNXDM-IGSM ONLY)
COMMUNICATION PORT
Wiring the LYNXDM-GSM/LYNXDM-IGSM
1. Install a jumper wire between terminals 2 and 3 on the communication modules's terminal strip.
2. Connect the 4-wire communication cable to the communication module's terminal strip (refer to Figure 5).
3. If you are installing a LYNXDM-IGSM, connect the incoming cable/DSL connector to the receptacle on the
communication module.
4. Secure the wiring to the built-in wire loops using tie wraps, as required.
5. After the wiring connections are complete, carefully reconnect the ribbon cable to the LYNXR-I front case
circuit board connector (properly aligning the red wire).
6. Snap the assembled LYNXR-I and the wall or desk mount front case to the mount's back case so it is
secured by the locking tabs.
4-WIRE
CABLE
LRR/IP
Figure 4 - LYNXDM-GSM/LYNXDM-IGSM Wire Routing
WIRE TIE
LOOPS
TAMPER
SWITCH
BATTERY PACK
1 2 3 4 5 6 7 8 9 10
RIBBON
CABLE
- 5 -
INTERNET
CONNECTION
(LYNXDM-IGSM ONLY)
MODE AND STATUS
INDICATOR SWITCH
11 12 13 14 15 16
09004-010-V0