Advertisement
About the Communications Module
The L5000-W-Fi communications module is intended to provide compatible Honeywell LYNX Touch control
panels with a Wi-Fi connection.
Compatible Controls
Control
LYNX Touch
TBD
QuickConnect Touch
TBD
The module connects directly to the control panel and is powered via the control panel's connection.
Mounting the Module
Mount the module component side up in the control panel as shown in Figure 1. Ensure that module's receptacle
is securely seated on the control's edge connector.
LYNX TOUCH
Programming Notes
Programming associated with the L5000-Wi-Fi module is accomplished as part of the Control Panel
Programming. Refer to the Control Panel Installation and Setup Guide for additional information.
1. The Remote Access Serial option must be set to "Enabled".
2. The Multi Mode Serial option must be set to "Enhanced Reports".
INSTALLATION GUIDE
Firmware Level
TBD
Figure 1. Installing the L5000-Wi-Fi Communications Module
Communications Module
Field Update Rev
800-10225 Rev. A 10/11
L5000-Wi-Fi
Installation Guide
800-10614
TBD
RECEPTACLE
L5000-WiFi
EDGE CONNECTOR
5000-100-205-V0
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Honeywell L5000-Wi-Fi
Summary of Contents for Honeywell L5000-Wi-Fi
- Page 1 Figure 1. Installing the L5000-Wi-Fi Communications Module Programming Notes Programming associated with the L5000-Wi-Fi module is accomplished as part of the Control Panel Programming. Refer to the Control Panel Installation and Setup Guide for additional information. 1. The Remote Access Serial option must be set to “Enabled”.
- Page 2 RF Exposure WARNING: The L5000-Wi-Fi must be installed to provide a separation distance of at least 20 cm from all persons. 2 Corporate Center Drive, Suite 100 P.O. Box 9040, Melville, NY 11747 Copyright ©...
Need help?
Do you have a question about the L5000-Wi-Fi and is the answer not in the manual?
Questions and answers