Output Led Indicator; Usage Tips; D.6.1) Door Panel Detection - Nabco Gyro Tech Acuvision Instruction Manual

.5 Output

Output LED Indicator

Right bank
of switches
9 - 16
Power
Status
Off
Operation LED's
Display off
D.6 Usage Tips

D.6.1) Door Panel Detection

For the Acuvision to work correctly, it must detect the door panel. If necessary use the Area
Minute Adjustment Mechanism to enable the detection area to reach the door panel, otherwise
the position of the door can not be detected resulting in improper operation. Use the LED
display as follows to confirm that the sensor detects the door panel.
When the green LED is blinking, the sensor is not detecting the door panel. When this happens,
auto-recognition will not function correctly. To correct this, make adjustments using the Area
Minute Adjustment Mechanism to tilt the detection area in toward the door.
If the amber LED is blinking when door is at full open position, or while door is opening from
mid-point of travel to full open, adjust the detection area outward away from the door.
(See page 13 in this Instruction Manual.)
D
Note:
Refer to page 7. If the sensor doesn't reliably recognize the fully closed door position, a closed
Page 17
Stand by
Fully Positions other
closed than fully
position closed
Green LED
LED's off
on
www.NabcoEntrances.com
or non-swing
side for swing
or non-fold
side of folding
doors
Power On
Detecting
Presence
Normal
Detection
Red LED Amber LED
on on
Acuvision Instruction Manual
N/A
DN0189
Mis-detection Out of order
Red LED
Respective
Blinks
LED Blinks
Continuously
05-11-10