Wiring - Sliding Door With U Series Control - Nabco Gyro Tech Acuvision Instruction Manual

D.2.2) Wiring - Sliding Door with U Series Control
Cut the (3) pin connector off of the existing Acusensor extension harness (PN # 22-9267).
Wire nut the two harnesses together as shown below. Insert the new Acuvision cable
(PN # 22-11023) into the hole in the header cover so the connector is on the exterior of the cover.
Mount the Acuvision Sensor. Note: Acuvision dipswitch Settings: (9 ON & 10 OFF)
HOLE ON
THE
HEADER
COVER
ACUVISION HARNESS
D.2.3) Wiring - Non-swing side of swing door or non-fold side of fold door with U Series Control
Insert new Acuvision cable (PN # 22-11023) into drilled hole in header. Cut Quick Disconnect
connector off main microprocessor harness as shown. Wire nut Acuvision harness to main harness
as shown below. Mount the Acuvision Sensor.
Note: Acuvision dipswitch Settings: (9 ON & 10 OFF)
HOLE ON
THE
HEADER
COVER
ACUVISION HARNESS
DN0183
Page 8
# 22-9267-00
ACUSENSOR
EXTENSION HARNESS
BROWN 12/24 VOLTS AC/DC
RED 12/24 VOLTS AC/DC
GREY INPUT
YELLOW INPUT COM
GREEN OUTPUT#1 COM
BLACK OUTPUT#1 N.O.
WHITE OUTPUT#2 N.O.
BLUE OUTPUT#2 COM
QUICK DISCONNECT ON
MICROPROCESSOR
MAIN HARNESS
BROWN 12/24 VOLTS AC/DC
RED 12/24 VOLTS AC/DC
GREY INPUT
YELLOW INPUT COM
WHITE OUTPUT#2 N.O.
BLUE OUTPUT#2 COM
GREEN OUTPUT#1 COM
BLACK OUTPUT#1 N.O.
www.NabcoEntrances.com
Acuvision Instruction Manual
Cut
GRAY
YELLOW
RED
NOT USED
NOT USED
NOT USED
NOT USED
Cut
BROWN
BLACK
RED
NOT USED
NOT USED
NOT USED
NOT USED
GRAY
RED
YELLOW
DN0183
BROWN
RED
BLACK
05-11-10