Problems When Projection Starts; Problems With The Remote Control - Yamaha LPX-510 Owner's Manual

When the Indicators Provide No Help

Problems when projection starts

Power does not turn on
Have you pressed the [Power] button?
Is "Key Lock" set to "ON"?
Is the
Do the indicators turn off and on when
the power cord is touched?

Problems with the remote control

The remote control does not work
Is the remote control light-emitting area
facing towards the remote control light-
receiving area when it is operated?
Is the remote control too far from the
projector?
Is direct sunlight or strong light from
fluorescent lamps shining onto the
remote control light-receiving area?
Are the batteries dead, or have the
batteries been inserted correctly?
48
indicator lit orange?
Press the button on the remote control or the [STANDBY/
ON] button on the projector's control panel.
If the "Key Lock" menu command is set to "ON", none of the
control panel buttons will operate. Press the
remote control.
"Setup" - "Operation" - "Lock Setting" - "Key Lock" (p.34)
Disconnect the power cord and then reconnect it. (p.6)
Check the circuit breaker to see if power is being supplied.
Turn off the projector's power, disconnect the power cord and then
reconnect it. If this does not fix the problem, there may be a
problem with the power cord. Stop using the projector, turn off the
main power switch, disconnect the power cord from the electrical
outlet, and contact your nearest dealer.
Face the remote control towards the remote control light-receiving
area.
The operating angle for the remote control is approximately ±30°
horizontally and approximately ±30° vertically. (Setup Guide)
The operating distance is approximately 7 m. (Setup Guide)
Set the projector up in a location where strong light will not shine
onto the remote control light-receiving area.
Insert new batteries, while making sure that they face correctly.
(Setup Guide)
button on the