Yamaha OneHome LPX-510 Installation Overview

OneHome
Manufacturer:
Model Number(s):
Comments:
Document Revision Date:
O S
VERVIEW AND UPPORTED
The projector includes an RS-232 connection to integrate with the OneHome system and provide reliable
communications.
T
HE PROJECTOR SUPPORTS THE FOLLOWING FEATURES
Input Selection and Power Control: Select any available input source, turn display off or on.
T
HE PROJECTORS DO NOT CURRENTLY SUPPORT THE FOLLOWING FEATURES
Display Modes: Changing display modes (such as Zoom or 4:3), is not supported from the OneHome
system.
I O
NSTALLATION VERVIEW
1. During the rough-in phase install the necessary power and video cabling for the projector installation.
2. Also during the rough-in phase, run a Cat5 wire from the location of the projector back to the Network
Assembly of the OneHome system to provide the serial connection needed to control the display.
3. Refer also to the RS-232 Connection Options Integration Note for other serial connection options.
4. Install the projector and related components.
5. Test the projector to ensure that the sources play correctly stand-alone.
6. Program the projector to enable RS-232 communications. Refer to Projector Programming.
7. Connect the OneHome system to the projector electrically. Refer to Connection Diagrams.
8. Configure the OneHome system for the projector and confirm communication between the projector
and the HomeBrick. Refer to HomeLogic Configuration Details.
9. Test the system by changing sources to confirm the correct video appears.
HomeLogic LLC
Yamaha
LPX-510
2/3/2006
F
EATURES
100 Hoods Lane Marblehead, MA 09145
Display Integration Note
:
:
Phone (781) 639-5155 Fax (781) 639-9677