User's Logo; On-Screen Display - Yamaha LPX-510 Owner's Manual

User's Logo

You can record your favorite image as a user's logo.
A user's logo can be stored for projecting when the projector starts up and when projecting the hide screen.
When a user's logo is recorded, the previous user's logo will be erased. Follow the instructions on the screen
to record a user 's logo. (Default setting:
Selection frame
ESC :Return :Select :Setting
Move the selection frame so that
the area of the image to be
recorded is inside the frame.
• • • •
The image will be displayed in dot format while the selection frame is displayed, therefore the display size
may change.
The size of the recorded image is 480 × 360 dots.
• • • •
• • • • Once a user's logo has been recorded, you cannot return the logo to the default setting.
• • • •
To use the stored user's logo, set "Hide Screen" to "Logo".

On-Screen Display

Main menu
Menu Position If using the projector's control panel, press the
menu display position. If using the remote control, tilt the
vertically.
Navigation Bar This sets the menu navigation bar to be displayed (ON) or not displayed (OFF).
Menu Color This selects the color of the main menu for full menus and the navigation bar to one of 4
choices.
Message This sets whether the following message is displayed (ON) or not displayed (OFF).
• • • •
Command name display when image signal, picture mode, aspect, test pattern or
memory settings are retrieved.
• • • •
Messages such as when no image signals are being input, when an incompatible signal
is input, and when the internal temperature rises
Hide Screen This sets the screen status when the
screen status can be selected from "Black", "Blue" or "Logo".
Startup screen This sets whether a startup screen (an image that is projected when projection starts) is to
be displayed (ON) or not displayed (OFF). When this setting is changed, turn off the
power, and when the cool-down
new setting will be applied after the power turns back on.
)
[User 's Logo]
Set the zoom rate
Zoom rate 100%
200%
300%
:Return :Select :Execute
ESC
Select the display ratio.
Function
−
, ,
button on the remote control is pressed. The
HIDE
period has finished, turn the power back on again. The
Using the Menu Functions
Record
and buttons to set the Center
button horizontally and
ON
Color 1
ON
Black
ON
Default
setting
35