Subscribe to Our Youtube Channel
Related Manuals for Master MFG 12 VOLT SPOT SPRAYER
Summary of Contents for Master MFG 12 VOLT SPOT SPRAYER
- Page 1 INSTRUCTIONS FOR ASSEMBLY, OPERATION, SERVICING & STORAGE 12 VOLT SPOT SPRAYERS 320.340.6464 12VSPT-M...
-
Page 2: Table Of Contents
SPOT SPRAYER COMPONENTS ........3 Congratulations on the purchase of your 12 Volt Spot Sprayer. This sprayer SPOT SPRAYER ASSEMBLY . -
Page 3: Tools Required & Included Hardware
320.340.6464 TOOLS REQUIRED THESE COMPONENTS ARE INCLUDED WITH COMPLETE BROADCAST SPRAYERS ONLY: CLOSELY INSPECT ALL CONTENTS 12V PUMP ASSEMBLY IN THE SHIPPING CARTON COMPONENTS • If you have damaged components: Contact the freight company that delivered the unit to file a claim. •... -
Page 4: Spot Sprayer Assembly
320.340.6464 SPOT SPRAYER ASSEMBLY PARTS PARTS None None Creates Drain Cap Assembly Applies Drain Cap to Drain Port Locate Sprayer Tank drain outlet. Press the Drain Cap Gasket into the Drain Cap until fully seated. Attach the Drain Tether to the top of the Drain Cap. Place other end of Tether over tank drain outlet. - Page 5 320.340.6464 PARTS PARTS NOTE: If you have a complete broadcast sprayer, skip this step and move on to step 7-9. Attaches Gun Clips to Sprayer Tank Attaches Gun Assembly to Sprayer Locate two screw holes on front of Sprayer Tank. Locate the Spray Gun Assembly and connect the hose to the hose barb coming out of the 12V Diaphragm Pump.
-
Page 6: Important Safety Information
320.340.6464 SPOT SPRAYER ASSEMBLY PARTS OPERATION - IMPORTANT SAFETY INFORMATION Now that you have assembled your sprayer, there is some important safety and health information you need to know with regard to handling and NOTE: Make sure Pressure spraying chemicals. Gauge is well seated, being careful not to over tighten. -
Page 7: Before Spraying
320.340.6464 BEFORE SPRAYING AFTER SPRAYING • Sprayer Prep: ALWAYS inspect and prepare the sprayer before use according to the • Clean Sprayer: ALWAYS clean the sprayer immediately after use according to the directions provided in this manual. directions provided in this manual. •... -
Page 8: Preparing Sprayer
320.340.6464 PREPARING SPRAYER USING SPRAYER (CONTINUED) • Review Safety Information: Review safety information in this manual • Broadcast Boom Valve: Close broadcast boom valve to prevent and manufacturer chemical label before use. dental spray release. acci • Turn On Power: Connect the wire harness to vehicle battery and •... -
Page 9: Operation - Cleaning, Decontaminating & Storage
320.340.6464 OPERATION - CLEANING, DECONTAMINATING & STORAGE SPRAYER STORAGE When done using the sprayer, it is always important to clean the sprayer and Prepare the sprayer for end-of-season storage by running RV anti-freeze through decontaminate yourself. Do not store the sprayer with chemicals in the tank, as it the system. -
Page 10: Troubleshooting
320.340.6464 TROUBLESHOOTING PROBLEM CAUSE SOLUTION Here you will find troubleshooting steps for some of the most common issues Pump Will Not Turn On Bad Electrical Connection Check Battery Connections Fuse Blown Replace Fuse users have with sprayers. Short In Wire Check Condition of Wires Low Voltage Check Voltage... -
Page 11: Sprayer Breakdowns
320.340.6464 SPRAYER BREAKDOWNS TRADITIONAL SPOT SPRAYER Part Number Description 15/25/40/60 Gallon Tank 33-103221 Tank Lid 33-103218 Drain Cap 33-103220 Drain Cap Gasket 33-103219 Drain Cap Tether 33-103222 Tank Lid Tether EF1000, EF2200-QA or EF3000-QA 1.0, 2.2 or 3.0 GPM Everflo Pumps EF-QC-A38 Hose Barb Fitting - QA x 3/8"... - Page 12 PLEASE FOLLOW ALL WARNINGS IN THIS MANUAL, FAILURE TO DO SO COULD RESULT IN PROPERTY DAMAGE & INJURY. 320.340.6464 12VSPT-M...
Need help?
Do you have a question about the 12 VOLT SPOT SPRAYER and is the answer not in the manual?
Questions and answers