Table of Contents
Advertisement
4. SIGNAL menu
TV60
SIGNAL
HORIZ. POSITION
0 - 999
VERT. POSITON
0 - 999
PHASE
TRACKING
0 - 999
OVER SCAN
100 - 90%
D-SUB INPUT
BLACK MASK
EXECUTE
SYNC NOISE
MASK
A/D SETTING
EXECUTE
ITEM
SETTING
HORIZ. POSITION
0 – 999*
VERT. POSITION
0 – 999*
PHASE
0 – 31*
TRACKING
0 – 9999*
OVER SCAN
100% – 90%*
D-SUB INPUT
AUTO
RGB
COMPONENT
BLACK MASK
EXECUTE
TOP
BOTTOM
LEFT
RIGHT
SYNC NOISE MASK
ON
BEGIN
END
A/D SETTING
EXECUTE
CLAMP POSITION Use to correct solid white or solid black in the projected image.
CLAMP WIDTH
VERT. SYNC
LPF
* The default value and the setting range differ depending on the input signals.
• Horizontal strips may appear on the enlarged projected image.
• When changing a horizontal or vertical position to a large extent, noise may appear.
• When you select COMPONENT as an input source, the setting of D-SUB INPUT will be changed to COMPONENT automatically.
• OVER SCAN and BLACK MASK are not available when the aspect ratio is set to SMART ZOOM (see page 18).
• OVER SCAN is not available when the aspect ratio is set to THROUGH (see page 18).
• If you increase the OVER SCAN setting when the projector is receiving the video signals, noise may appear on the screen. In such case,
decrease the OVER SCAN setting.
26
0 - 31
AUTO
ON
FUNCTION
Use to adjust the horizontal position of the projected image.
Use to adjust the vertical position of the projected image. The adjustable range varies
depending on the type of the input signal. In some cases, the image may stay in the same
position even when the setting value is changed.
Use to eliminate flickering or blur, if it appears while viewing the projected image.
Use to eliminate vertical wide stripes, if it appears, while viewing the projected image.
Use to adjust the over scan ratio for the video signals.
When the projector detects the three-wire system (YC
(RGBHV), it automatically selects either COMPONENT or RGB accordingly.
Select this option when connecting the projector to high definition video equipment having
R, G, and B output terminals.
Select this option when connecting the projector to a DVD player or other equipments having
Y, C
, and C
(or Y, P
B
R
Use to adjust the image when the noise appears on the projected image.
Adjust the image when the noise appears on the top part of the image.
Adjust the image when the noise appears on the bottom part of the image.
Adjust the image when the noise appears on the left part of the image.
Adjust the image when the noise appears on the rigtht part of the image.
Use to adjust the image when flagging occurs near the top of the screen.
, OFF
Use to adjust the start of the sync noise mask position.
Use to adjust the end of the sync noise mask position.
Use to adjust the Analog Digital conversion parameters.
Use to correct solid black in the projected image.
Use to adjust the image when its motion does not run smoothly.
Use to reduce the streak noise appeared on the image. (see page 29).
, and P
) component video output terminals.
B
R
C
/ YP
P
) or five-wire system
B
R
B
R
Advertisement
Table of Contents
