Table of Contents
Advertisement
ST-292 User's manual
In order to change the channel, press and hold the channel change button. After the
control light on the sensor flashes, the process of channel change has been initiated.
Hold the button and wait until the light starts flashing again. The number of flashes
corresponds to the first digit of the desired channel number.
Release the button after the desired number of flashes and press it again to set the
second digit of the channel number – the control light flashes quickly twice. Hold the
button and wait until the light flashes the desired number of times. When the button is
released, the control light flashes twice – the new communication channel has been set.
NOTE: In case of a one-digit channel number (channels 0÷9) set 0 as the first digit.
Example 1:
28 is the desired communication channel. In order to select this channel, set the first
digit - 2, and the second digit – 8.
Press and hold the channel change button - the control light flashes quickly once - the
process of channel change has been initiated. Hold the button and wait until the light
flashes two more times (the first digit of the channel number – 28).
Release the button and press it again – the control light flashes quickly twice – the
process of setting the second digit has been initiated. Hold the button and wait until the
light flashes 8 times. When the button is released, the control light flashes quickly twice
– the new communication channel has been successfully set.
Example 2:
7 is the desired communication channel. In order to select this channel, set the first digit
- 0, and the second digit – 7.
Press and hold the channel change button - the control light flashes quickly once - the
process of channel change has been initiated. As the first digit is 0, release the button
before the control light flashes again. Press the button again – the control light flashes
quickly twice – the process of setting the second digit has been initiated. Hold the button
and wait until the light flashes 7 times (the second digit of the desired number). When
the button is released, the control light flashes quickly twice – the new communication
channel has been successfully set.
In case of errors in the channel change process, the control light goes on for ca. 2
seconds. In such a case the channel will not be changed.
VI.
First start-up
In order for the controller to operate correctly, the following steps must be followed when
starting the device for the first time:
1. Insert the batteries.
WARNING
!
While inserting new batteries the user must not press the touch buttons
2. Connect the regulator with the heating device via a two-core cable. In the case
of ST-292v2 version, the two-core cable should be plugged into appropriate
sockets in the receiver.
3. In the case of using a wireless room regulator, it is necessary to check if the
current communication channel selected in the regulator is the same as in the
receiver. "35" is the default communication channel in all devices. If there is a
conflict with other devices using radio communication, the user needs to select a
different channel.
7
Advertisement
Table of Contents
