Table of Contents
Advertisement
IV.
Receiver for wireless controller
ST-292v2
regulator
with the heating device (or the CH
boiler controller) via radio signal sent
to
the
receiver.
connected to the heating device (or
CH boiler controller) via a two-core
cable whereas the communication
with the room regulator is performed
wirelessly via radio signal.
The receiver has the following control
lights:
• green 1 – indicates data reception, goes on during channel change;
• red – indicates receiver operation
• green 2 – goes on when the room temperature fails to reach the pre-set temperature
– the heating device is switched on.
How to change the communication channel
Channel "35" is the default communication channel in the room regulator. The channel
may be easily changed (if the current channel is used by other devices). To change the
channel, press and hold the channel change button for about 10 seconds until the green
control light (1) goes on. Next, change the communication channel in the room regulator
following the procedure described in part V.c.10. The green light on the receiver should
go off.
V.
External temperature sensor
ST-292v2 room regulator may optionally be equipped with an external temperature
sensor. The sensor should be mounted in a shaded place so that it is not affected by the
weather conditions. The current temperature value will be sent to the room regulator
every few minutes and it will be displayed on the main screen.
The external sensor communicates with the room regulator via radio signal. Both the
room regulator and the external sensor are pre-configured to operate on channel "35",
but the user may easily change the channel (if the current channel is used by other
devices).
How to change communication channel:
communicates
The
receiver
is
6
TECH
Advertisement
Table of Contents
